CNC Section/Profile/Angle Roll Bending Machine


CNC Section/Tube/Plate Roll Bender HCA Series

iNFEME HCA series of CNC roller bender is hydraulic driven.

Available in 2 driving forces i.e. 15, & 25 ton.

SKU: N/A Category:


Angle Roll Bending Machine Features

CNC Control Software Hardware
  • Smart CNC, easy to learn
  • Up to 18 radii per bar
  • Up to 30-pass roll forming
  • DXF file upload
  • Control of tangents
  • S curve, Ellipse, spline and spiralling bending tools
  • Pressure calculator
  • Roller design assit
  • Spring back calculator
  • Automatic positioning of bends
  • 15 inch touch screen IPC & movable control panel
  • Vertical and horizontal working position
  • Work bench precisely machined from one whole piece of cast iron and heat treated
  • X shaft repeat positioning accuracy 0.01mm
  • Lower 2 shafts individually driven by planetary gearbox
  • Roller speed infinitely adjustable
  • Automatic lubrication of conveyors
  • Automatic switch off hydraulics
  • Clash protection of rollers
  • Servo electric & servo hydraulic
  • Left and/or right photoelectric position detector


Angle Roll Bending Machine Specifications

8V2-12T 8V2-25T
Pressing power 12 ton 25 ton
Positioning accuracy servo controlled 0.01mm 0.01mm
Drive system Hydraulic Hydraulic
Stroke(controlled) 150mm 260mm
Hydraulic oil volume 9 litres 18 litres
Upper roller driven by servo hydraulic Yes Yes
Lower 2 rollers separately driven by planetary gearbox Yes Yes
Infinitely adjustable roller speed 1- 30 rpm 1- 22 rpm
Maximum torque upper roller 900Nm 2200Nm
Maximum torque lower roller 260Nm 550Nm
Shaft height 180mm 330mm
Shaft diamter 50mm 80mm
Roller support Series Series
Lower roller spacing 180-390mm 280-760mm
Manual Series Series
Power connection 380V 50Hz 16.3A 380V 50Hz 28.7A
Length/width/height 1750*800*1750 2040*1200*2200

Note: Technical data, capacities and specifications are not binding and may be modified without prior notice

Angle Roll Bending Machine Bending capacity

8V2-12T 8V2-25T
mm R min. mm R min.
Round tube 2”(60) 300 4”(114) 600
Square tube 50/50/3 300 160/160/4 1000
Angle(leg-out) 50/50/5 300 80/80/8 600
Flat bar(easy way) 100/10 150 300/15 300
Flat bar(hard way) 70/12 300 120/15 1000
Solid round 30 150 60 500
Solid sqaure 30/30 150 60/60 500
C-Channel(easy way) UNP80 400 UNP180 600
C-Channel(hard way) UNP80 400 UNP180 600
T-Channel(easy way) 60/60/7 400 80/80/8 500
T-Channel(hard way) 60/60/7 400 80/80/8 500

Note: The minimum radii shown may require Multi-Pass.


There are no reviews yet.

Be the first to review “CNC Section/Profile/Angle Roll Bending Machine”

Your email address will not be published.

Go to Top